Annular Cutter 1-1/16 in x 1 in for Mag Drill - Durable HSS Cutters

In this review of the S&F STEAD & FAST annular cutter the bottom line is simple: this cutter is aimed at fabricators and trade professionals who need clean, burr-free holes from a mag drill with a short, tough cutting edge. The most compelling reason to buy is its M2AL high speed steel construction and CNC finish, which deliver consistent hole quality and precise edge finish when used correctly. The review focuses on real-world usability, compatibility with popular mag drill brands, and practical cautions for avoiding premature wear.

Key Features

• M2AL HSS material: Provides high wear resistance and durability for extended service life under steady, correct feed rates.
• 1-1/16 in cutting diameter: Produces reamed, burr-free holes suitable for structural and fabrication tasks where a clean edge matters.
• 1 in depth of cut: Designed for single-layer drilling of plate materials, keeping cuts precise without overreaching the cutter's intended use.
• 3/4 in Weldon shank: The CNC-machined shank with two flats ensures secure clamping in mag drill arbors and consistent concentricity.
• Included plastic case and pilot pin: Keeps the cutter and pilot pin protected and ready for transport or storage between jobs.

Who It's For

This annular cutter suits machinists, structural steel workers, and site fabricators who use magnetic drill presses and need a reliable, precise cutter for single-layer steel plates. It is also a good choice for those who value a CNC-finished edge and compatibility with major mag drill brands such as Alfra, BDS, Dewalt, Fein, Euroboor, Hougen, and Ruko.

It is not the right tool for drilling stacked or multiple layers of material, and hobbyists who expect aggressive feed without attention to technique may prefer a different cutter or coating. Users who plan to use a conventional drill press will need to purchase an arbor separately.

Pros & Cons

Pros

• Well-made HSS construction gives good cut quality and long service life when used with proper feed rates.
• CNC-machined finish and Weldon shank deliver precise, burr-free holes and secure clamping.
• Compatible with a wide range of mag drills, making it versatile across brands.

Cons

• Mixed reports on sharpness and durability mean performance depends on technique and material; some users reported the cutter stopped biting sooner than expected.
• Not designed for multiple-layer drilling and requires an extra arbor for drill press use, which adds cost for some setups.

Specifications

Brand	S&F STEAD & FAST
Cutting diameter	1-1/16 in
Depth of cut	1 in
Material	M2AL high speed steel (HSS)
Shank	3/4 in Weldon shank with 2 flats
Includes	One annular cutter, one pilot pin, plastic case
Compatibility	Mag drills: Alfra, BDS, Dewalt, Fein, Euroboor, Hougen, Ruko

Our Verdict

The S&F STEAD & FAST 1-1/16 in annular cutter is a sensible buy for professionals who require clean, accurate holes from a mag drill and who follow recommended feed and single-layer drilling practices. It represents good value when matched with the correct arbor and used with steady pressure; users seeking aggressive multi-layer cutting or who want a plug-and-play option for a drill press should note the arbor requirement and possible variability in sharpness over time.

Frequently Asked Questions

Can this cutter be used on a drill press?
Yes, but an annular cutter arbor is required for drill press use and is not included in the pack.

Is this cutter suitable for stacking plates?
No, this series is designed for single-layer drilling only and is not intended for multiple stacked layers.

What should I do to avoid premature failure?
Use a low feed rate when engaging the cutter, increase feed after 2-3 mm of penetration, apply firm steady pressure, and secure the workpiece to prevent movement.