Anton D-TAP to 2 pin Male Power Cable for Teradek - Flexible 23.6in

In this review of the Anton D-TAP to 2 pin Male Power Cable for Teradek, the bottom line is clear: this cable is aimed at shooters and monitor operators who need a slimmer, more flexible D-Tap lead for powering Teradek or SmallHD devices. The single biggest reason to buy is its improved flexibility and reduced bulk compared with standard power leads, which makes cable routing easier on gimbals, rigs and crowded carts. Our review highlights build quality, length options and the important compatibility notes you need before ordering.

Key Features

• Flexible thin jacket: The cable is noticeably more flexible and thinner than standard alternatives, helping reduce strain and clutter when run through tight spaces or around camera rigs.
• Teradek/SmallHD compatibility: The wiring and connector combination is intended specifically for Teradek and SmallHD devices, so users will get a direct power feed without adapters when using those brands.
• Right angle 2 pin male: The right angle 0B 2 pin male connector keeps the connector profile low at the device, which is useful when space behind a monitor or receiver is limited.
• Standard male D-Tap: The opposite end uses a standard male D-Tap plug that fits common D-Tap power outputs on V-mount or Gold mount battery plates.
• Tested before shipping: Each cable is tested to ensure there are no shorts or potential breakdowns, offering extra reassurance out of the box.
• Custom length option: The default 60cm (23.6in) length is convenient for many setups, and custom lengths are available on request for specific rig needs.

Who It's For

This cable is best for camera operators, gimbal pilots and DITs who power Teradek or SmallHD gear from camera batteries and prefer a low-profile, flexible lead that tucks neatly behind monitors and receivers. The right angle 2 pin connector and thin jacket make it a practical choice for compact setups and frequent setup changes.

Those who should look elsewhere include people who need a cable for Bartech Focus Device Receiver, as this exact cable is not compatible with that device, and anyone who wants a heavier-duty, ruggedized power lead for extremely demanding field conditions where thicker insulation is preferred.

Pros & Cons

Pros

• Smaller, more flexible jacket reduces bulk and improves cable routing on rigs.
• Correct connector pair for Teradek and SmallHD equipment without adapters.
• Right angle 2 pin male connector reduces strain and keeps connectors close to devices.
• Tested before shipping and option for custom lengths adds convenience.

Cons

• Some users report isolated reliability issues such as a pin breakage under heavy use, so it may not be as rugged as thicker cables.
• Not compatible with Bartech Focus Device Receiver, requiring a different cable for that unit.

Specifications

Our Verdict

The Anton D-TAP to 2 pin Male Power Cable is a practical, value-conscious choice for anyone powering Teradek or SmallHD devices who needs a more flexible, low-profile lead. It is good value for most studio and run-and-gun workflows, particularly when custom length options are used to reduce excess cable. Buyers seeking maximum ruggedness or Bartech compatibility should consider alternate cables.

Frequently Asked Questions

Is this cable compatible with Bartech Focus Device Receiver?
No. This specific cable is not intended for Bartech Focus Device Receiver; check other listings or contact the seller for the correct cable.

Can I get a different length?
Yes. The standard length is 60cm (23.6in) and the seller can customize lengths if you message them before ordering.

What testing is done before shipping?
Every cable is tested to ensure there are no short circuits or potential breakdown problems prior to shipment; contact support if you receive a defective unit.