Metal ROOFING SCREWS 10 x 2 in Fab Charcoal Hex Head - Durable Fixings

In this review of the Metal ROOFING SCREWS (250) 10 x 2 in Fab Charcoal, the bottom line is simple: these are practical, no-nonsense fasteners for anyone mounting metal roofing to wood who wants a close color match and reliable sealing. The reviewer found they install quickly with a standard 1/4 in hex driver, the EPDM washer gives a solid weather seal, and the painted heads blend well with common charcoal roof panels. If you need quantity and consistency for a roof or siding project, this pack is worth considering.

Key Features

• 1/4 in hex head: The standard hex drive makes these screws quick to run with a speed bit or impact driver for efficient installation.
• 1/2 in EPDM washer: The sizable washer provides dependable sealing between the metal panel and the screw head to reduce water ingress.
• Sharp T17 point: The self-starting tip pierces metal and grabs into wood rapidly, reducing pre-drilling for most common roofing panels.
• Painted colored head: Two-part polyurethane paint helps the heads match roof panels and resists finish wear longer than simple coatings.
• Galvanized shaft: Corrosion resistance on the shaft protects the fastener where it contacts the metal and wood over time.
• Pack quantity: With 250 screws in the box, this pack covers multiple panels and small-to-medium roofing jobs without frequent reordering.

Who It's For

These screws are aimed at contractors, roof installers, and experienced homeowners working on metal roofs or metal-clad siding attached to wood framing. The combination of a sharp T17 point and a 1/2 in EPDM washer suits routine metal-to-wood fastening where speed and a weather-tight seal matter.

Those who should look elsewhere include installers who require stainless steel fasteners for marine or highly corrosive environments, or projects that demand exact color-matching from a manufacturer-matched chip; the painted heads closely match many brands but color may vary slightly with batch and panel finish.

Pros & Cons

Pros

• Good value for money when you need bulk fasteners for a roof or siding job.
• Reliable weather sealing thanks to the 1/2 in EPDM washer under the painted head.
• Fast, secure installation with the sharp T17 point and 1/4 in hex drive.
• Painted heads help the screws blend with common charcoal panels for a neater finish.

Cons

• Color variation is possible between batches, so exact matches to specific panels are not guaranteed.
• These are galvanized shafts rather than stainless, so extreme coastal conditions may warrant a different fastener.

Specifications

Head drive	1/4 in hex head
Washer	1/2 in EPDM washer
Shaft diameter	.19 in
Washer width	.5 in
Length under head	2 in
Point type	Sharp T17 self-starting point
Finish	Painted colored head, galvanized shaft

Our Verdict

For routine metal-to-wood roofing and siding work this pack of 10 x 2 in charcoal head screws represents solid value: they install rapidly, seal well with the EPDM washer, and the painted heads usually blend with common panel colors. Choose them for standard residential and light commercial projects, but specify stainless fasteners for aggressive corrosive environments or when an exact factory color match is critical.

Frequently Asked Questions

Do these screws require a special bit?
No, they use a common 1/4 in hex driver or bit that fits standard impact drivers and cordless drills.

Will the EPDM washer keep the roof watertight?
The 1/2 in EPDM washer provides a reliable seal for typical installations, but correct seating and not over-torquing are important for long-term performance.

Are these stainless steel?
No, the shafts are galvanized for corrosion resistance; stainless would be preferable for very salty or highly corrosive locations.