One Mfg Lips Snowboard Stomp Pad 5 in x 5 in - Lightweight Traction

Our review of the One Mfg Lips Snowboard Stomp Pad 5 in x 5 in finds it to be a simple, effective traction upgrade for riders who want lightweight, reliable grip without bulk. Designed and made in the USA, this stomp pad uses molded 7mm spikes and a thermoplastic construction to provide confident purchase when getting on and off lifts or landing a one footer. For riders who value low weight and clean graphics but still need solid anti-slip performance, this stomp pad delivers a lot of utility for a small, inexpensive addition to a board.

Key Features

• Light weight construction: The thin thermoplastic build adds minimal mass to the board while still providing a durable contact point for boots.
• 7mm molded spikes: Raised spikes are designed to give positive traction under boot soles so riders can balance and stomp without slipping.
• Pressure sensitive adhesive: The factory adhesive is made to stick to smooth or textured top sheets and hold through cold conditions when applied per instructions.
• Smooth edges and finish: The pad is finished so it will not abrade or tear clothing or gloves when carrying the board.
• Made in the USA: Developed, tested and manufactured domestically and packaged with reduced exterior film for simpler recycling.

Who It's For

This stomp pad is best for alpine and freestyle snowboarders who need a compact traction point in front of the rear binding for lift ramps, quick stops, or playful one footer tricks. Its lightweight design suits riders who care about keeping board weight down while still adding defined grip.

Riders looking for full-foot traction systems, large pad coverage, or multi-piece adjustable pads should look elsewhere, as this single 5 in x 5 in pad is meant as a targeted traction spot rather than a full replacement for larger traction setups.

Pros & Cons

Pros

• Lightweight and low-profile, so it does not significantly change board balance.
• Molded 7mm spikes provide clear, usable grip for boots when loading or dismounting lifts.
• Durable thermoplastic construction stands up to repeated use on the mountain.
• Made in the USA with minimal exterior packaging for simpler recycling.

Cons

• Single 5 in x 5 in pad provides only localized traction and is not a full-foot cover for every boot placement.
• Adhesive requires careful surface preparation and overnight cure for best hold, so it is not ideal for last-minute installs.

Specifications

Our Verdict

The One Mfg Lips 5 in x 5 in stomp pad is a smart, affordable choice for riders who want a simple traction point that is light and reliable. It performs well for lift ramp stability and casual tricks, and its durable thermoplastic spikes and strong adhesive make it good value for anyone needing targeted grip without heavy or bulky hardware.

Frequently Asked Questions

How do I apply the stomp pad?
Clean and warm the board surface, test place the pad, mark corners, remove backing paper, press firmly over the entire pad and let cure overnight.

Will the pad damage my board top sheet?
The pad has a smooth finished edge designed not to abrade or tear clothing or gloves and uses an adhesive meant for snowboard top sheets when applied correctly.

Is this pad suitable for all boots?
Yes, the molded 7 mm spikes give positive traction for most snowboard boots, though the 5 in x 5 in size is a localized traction spot rather than full-coverage for every boot stance.