XRDS -RF RG8X Coaxial Cable 50FT 50 Ohm - Low Loss Signal

In this review the XRDS -RF RG8X coaxial cable is evaluated for ham radio operators, CB users, and anyone who needs a reliable run between transceiver and antenna. The bottom line: this 50ft, 50 ohm cable delivers notably low loss and clean signal transfer thanks to a solid copper core and dual shielding, making it a sensible pick for installations where maintaining high-frequency integrity matters. For those seeking a durable, flexible feed line that supports up to 600 MHz, this cable earns consideration without extravagant cost.

Key Features

• Solid Copper Core: The solid copper inner conductor provides consistent conductivity for clearer reception and reduced signal attenuation on high-frequency transmissions.
• Dual Shielding: The combination of a foil layer and a pure copper braid offers strong protection against RF interference and improves overall signal reliability.
• PE Dielectric Layer: The polyethylene dielectric helps maintain impedance stability across the cable length for predictable performance up to 600 MHz.
• Durable PVC Jacket: The outer PVC jacket gives flexibility for routing and added resistance to wear, suitable for both indoor and sheltered outdoor use.
• 50 Ohm Impedance: Matched impedance ensures compatibility with common radio equipment and antennas used by CB and ham radio operators.

Who It's For

This cable is aimed at amateur radio enthusiasts, CB operators, and installers who need a reliable 50 ft feed line that balances low loss with physical durability. It is particularly useful when running cable between a transceiver and rooftop or mast-mounted antenna where maintaining signal clarity up to 600 MHz is important.

Those who need ultra-rugged, direct burial cable or pre-terminated cable assemblies should look elsewhere, since this product is supplied as jacketed coax suited to above-ground or protected outdoor runs and may require connectors to be attached by the user or installer.

Pros & Cons

Pros

• Solid copper conductor reduces resistance for better high-frequency performance.
• Dual shielding (foil and pure copper braid) helps block interference in busy RF environments.
• Flexible PVC jacket makes routing and handling easier during installation.

Cons

• Not rated as direct burial cable, so it may need additional protection for long-term outdoor ground runs.
• Sold without connectors attached, so users will need tools or a service to fit ends for their specific equipment.

Specifications

Brand	XRDS -RF
Length	50 ft
Impedance	50 ohm
Frequency Range	Up to 600 MHz
Conductor	Solid copper core
Shielding	Foil plus pure copper braid (dual shielding)
Jacket	PVC outer jacket

Our Verdict

The XRDS -RF RG8X 50 ft coaxial cable is a practical, value-conscious choice for amateur and CB radio users who need a low-loss, well-shielded feed line. Its solid copper core and dual shielding deliver dependable signal quality up to 600 MHz, and the PVC jacket balances flexibility with durability. Buy this cable if you plan above-ground or protected outdoor runs and can terminate connectors to match your gear.

Frequently Asked Questions

Can this cable be used with CB and ham radios?
Yes. The 50 ohm impedance and support up to 600 MHz make it compatible with most CB and amateur radio equipment when properly terminated.

Is the jacket suitable for outdoor use?
The PVC jacket is durable and flexible for sheltered outdoor or rooftop runs, but the cable is not specified for direct burial without additional protection.

Does the cable come with connectors attached?
No. This cable is supplied as jacketed coax and will require connectors to be fitted to match your transceiver and antenna.